Dry Contact – 15′ Cable

Dry Contact – 15′ Cable

$109.00

Add to Quote

Description

Dry Contact Sensors

Dry contact sensors are user definable and can be used to detect many different inputs

The Dry Contact sensor is a simple connection to burglar alarms, fire alarms or any application that requires monitoring by the sensorProbe.

Additional information

Option

, ,

Dry Contact Sensors

The Dry Contact sensor is a simple connection to burglar alarms, fire alarms or any application that requires monitoring by the sensorProbe. Dry contact sensors are user definable and can be used to detect many different inputs such as UPS status, security systems, air conditioning status.

These general purpose switches can be either input or output. When used as an output it can source up to 20 mAmps. You can select the output voltage by setting the Output Level to a Low or a High. When set to Low the pin will output 0 volts. When set as a High the pin will output 5 volts.

When used as an input a switch will retain any error condition until it is read via SNMP. Therefore if a switch encounters a critical condition at any time it must report that condition before it can return to a normal state.

Input pins can be used to detect whether or not an input switch is open or closed. In combination with external sensors, input pins can detect whether a door or window is open or closed, if there is a water incursion and many other conditions.

Specifications

Specifications

Measurement Range Input: Alarm or Normal
Output : Set or Reset
Sensor Type Input : Open / Closed contact switch
Output : High (5V) / Low (GND)
Contact voltage range 5 volts pulled-up dry contacts*
Input Measurement Rate Multiple readings every second
  Normal input state is settable under software
Electrical Output Can sink up to 20mA**, when set to Low
   
Interface  
Communications Cable RJ-45 jack to sensor using UTP Cat 5 wire
Communications Cable Max. length 1000Ft (305m) with approved low capacitance shielded cable or UTP
Power Source Powered by the base unit. No additional power needed
  Full autosense including disconnect alarm
Important Note *Dry Contacts are not isolated, don’t connect any voltage source
** Dry contact output is not suitable for direcly driving a relay
Sensor count 1

Video Presentation

3D View


View Separately