This product can be connected to both the sensorProbe or securityProbe base units.
Monitoring for developing smoke is an essential aspect in the security and safety of any facility.
AKCP has designed a smoke sensor specifically for use with its sensorProbe, SensorProbe X+ and securityProbe productline. These smoke detectors are easy to install and configure and can be used in conjunction with all other of AKCP’s alerting features.
Monitoring for developing smoke is an essential aspect in the security and safety of any facility.
AKCP has designed a smoke sensor specifically for use with its sensorProbe and securityProbe productline. These smoke detectors are easy to install and configure and can be used in conjunction with all other of AKCP’s alerting features.
Specifications
Specifications
Measurement Range
Smoke or No Smoke
Sensor Type
Photoelectric Detector Type, Suitable for installation to BS 5839 pt 6 Grade F
Output Type
Open/Closed contact switch
Features
Loud piercing 85db alarm at 3m, Full function test button, Alarm auto-reset, Insect resistant chamber, Low profile design for ceiling mounting for maximum smoke detection
Measurement Rate
Multiple readings every second
Indication
LED for Status, Strobe Light when Smoke is detected
Operating Temperature
-20 °C~60 °C, 4 °F~140 °F
Interface
Communications Cable
RJ-45 jack to sensor using UTP Cat 5 wire
Communications Cable Max. length
The Spot Water Sensor can be extended from the RJ-45 Intelligent Sensor ports on the base units up to 500 feet, or 150 meters using standard CAT5/6 LAN cable
Power Source
Interface module powered by the base unit.
Internal battery inside smoke detector.
Full autosense including disconnect alarm
Power Consumption
Typical 290 mWatt, 58mA
Dimensions
Diameter 100mm, height 28mm
Mounting
Screw mounting
Sensor count
1
Features
Accurate, cost effective Smoke Detector
On/Off alarm signal of Smoke Detected
LED indicates the status of Smoke Detector
Low profile design for ceiling mounting for maximum smoke detection
Sensor type – open/closed contact switch
Up to 2 Smoke Detector Sensors per sensorProbe2, and 8 per sensorProbe8/securityProbe
Includes disconnect alarm that checks that the sensor is securely plugged into the sensor/securityProbe
The smoke detector can also be attached to dry contacts of a X20 or X60 unit
With 9V battery as backup the sensor/securityProbe will still work as a smoke detector on its own
